Spark detektion

Diese Seite ist im Aufbau – eine deutsche Version folgt in Kürze.

Spark detection is designed to prevent a fire or possible explosion, which is under development, by detecting a change in the system,
and spraying water into the piping system. The plant works in two levels:
1. Prevention – sprays water
2. Alarm, – closes system

The system is designed to be fail-safe, and also works in the event of a power failure.

The system works by 2 cameras detecting light levels inside the transport pipe,
these are mounted opposite each other at the outlet from the hammer mill.

The light-sensitive cameras are connected to a controller which is equipped with a battery backup in the event of a power failure.
At level 1, the control ensures that a water valve is opened so that water is sprayed into the transport pipe.
At level 2, the system sprays water and gives an I / O to close down the operating system.
The controller also monitors water and power supply, and gives an alarm if there is a fault in this.

The water nozzle is mounted on top of the pipe at the inlet to a cyclone or filter, 1 meter before.
The nozzle itself is mounted flat with the inside diameter of the pipe, so that material passage in the pipe is not prevented.

Placering af vanddyse på et filter.

The system is supplied with a 50-liter water tank and a pressure pump, which ensures that there is always pressure on the system.
All fittings etc., and correct hole drilling tool for the installation of sensors and nozzle are included.